F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Engine Block Heater: Service and Repair
Block Heater - 6.4L Diesel
Block Heater - 6.4L Diesel
Removal and Installation
1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Drain the cooling system.
3. Disconnect the block heater electrical connector.
4. Remove the block heater and discard the O-ring seal.
^
To install, tighten to 41 Nm (30 lb-ft).
^
Install a new O-ring seal.
5. To install, reverse the removal procedure.
