F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
may be damaged.
Using an appropriate tool, dislodge the glow plug wiring harness seals from the valve cover.
10. Disconnect the glow plug electrical connectors by pulling on the glow plug wiring harness tee above the seal. Remove the glow plug wiring
harness.
11. Remove the 4 turbocharger crossover tube bolts.
^
To install, tighten to 31 Nm (23 lb-ft).
12. Disconnect the EP sensor tube fitting from the EGR oxidation pipe.
^
To install, tighten to 20 Nm (177 lb-inch).
13. Remove the nut and the EP sensor and tube assembly.
^
To install, tighten to 9 Nm (80 lb-inch).
14. Remove the LH valve cover bracket nuts.
^
To install, tighten to 9 Nm (80 lb-inch).
15. Remove the LH valve cover bracket assembly nuts. Separate and remove the upper and lower LH valve cover brackets.
^
To install, tighten to 31 Nm (23 lb-ft).
16. Remove the bolts, the stud bolts and the LH valve cover. Remove the discard the valve cover gasket.
^
To install, tighten to 9 Nm (80 lb-inch).
17. To install, reverse the removal procedure.
^
Alternate tightening the valve cover bolts to tighten evenly.
^
Make sure that the turbocharger crossover tube is square to the turbocharger when the valve cover bracket is installed.
