F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
31. Remove the bolt. Remove the oil level indicator and tube and position aside.
^
Remove and discard the O-ring seal.
32. Disconnect the fuel hoses at the engine.
^
Plug or cap the openings.
33. Remove and discard the center bolt for the LH engine mount.
34. CAUTION: The engine mount bracket bolts must be discarded and new bolts installed, or damage to the vehicle may occur. They are a
torque-to-yield design and cannot be reused.
Remove and discard the 4 bolts and the LH engine mount bracket and mount.
^
Rotate the LH engine mount bracket to the front and then remove the LH engine mount. Remove the LH engine mount bracket.
Installation
1. Clean the engine support insulator-to-cylinder block and engine support insulator-to-frame mating surfaces of any dirt or foreign material prior to
installation.
2. CAUTION: The engine mount bracket bolts must be discarded and new bolts installed, or damage to the vehicle may occur. They are a
torque-to-yield design and cannot be reused.
CAUTION: The engine mount bracket bolts must not be tightened more than 90 degrees after initial torque or damage to the bolts may
occur.
