ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Engine - 6.4L Diesel Belt/Idler Pulley Chirp On Start Up|Page 2632 > < Engine - 6.4L Diesel Belt/Idler Pulley Chirp On Start Up|Page 2626
Page 1
background image

Idler Pulley: All Technical Service Bulletins
Engine - 6.4L Diesel Belt/Idler Pulley Chirp On Start Up

TSB 09-9-8

05/18/09

6.4L DIESEL - COLD WEATHER BELT CHIRP

FORD:
2008-2009 F-Super Duty

This article supersedes TSB 07-23-9 to update model year, Service Procedure and Part List.

ISSUE
Some 2008-2009 F-Super Duty vehicles equipped with a 6.4L diesel may exhibit a front end accessory drive (FEAD) belt chirp when initially started
following a cold soak.

ACTION
Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

1.

On 2008 model year vehicles built on or before 11/9/2007 and equipped with single alternator, replace the idler pulley following Workshop
Manual Section 303-05. (Figure 1)

2.

On 2008 model year vehicles built on or before 11/9/2007 and equipped with dual alternator, replace the idler pulley following Workshop Manual
Section 303-05. (Figure 1)

3.

On 2008 and 2009 model year vehicles equipped with single alternator, replace the main FEAD drive belt with a new service belt that has an
improved noise resistant rubber compound.

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage 
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

OPERATION

DESCRIPTION

TIME

090908A

2008-2009 F-Super Duty

1.6 Hrs.

6.4L: Replace The FEAD
Belt Only, Includes Time
To Remove And Install
The Upper Fan Shroud
(This Labor Operation Is

Engine - 6.4L Diesel Belt/Idler Pulley Chirp On Start Up|Page 2632 > < Engine - 6.4L Diesel Belt/Idler Pulley Chirp On Start Up|Page 2626