F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
shown.
^
Stage 1: Tighten to 25 Nm (18 lb-ft).
^
Stage 2: Tighten again to 25 Nm (18 lb-ft).
2. Install the 3 spacers on the exhaust manifold stud bolts.
^
Tighten to 19 Nm (168 lb-inch).
3. Position the exhaust manifold heat shield. Install the nut and bolts.
^
Tighten to 19 Nm (168 lb-inch).
Vehicles with A/C
4. NOTE: Install a new O-ring seal and gasket.
Install the A/C hoses and nuts.
^
Tighten to 15 Nm (133 lb-inch).
5. Position back and connect the A/C compressor wire retainer.
All vehicles
6. Position back the starter wiring. Install the retaining nuts for the starter solenoid wiring.
^
Tighten the large nut to 12 Nm (106 lb-inch) and the small nut to 6 Nm (53 lb-inch).
