F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
3. Loosely install new RH turbocharger inlet pipe-to-exhaust manifold nuts.
4. Tighten the RH turbocharger inlet pipe-to-turbocharger bolts and RH turbocharger inlet pipe-to-exhaust manifold nuts.
1
Tighten the bolts to 25 Nm (18 lb-ft).
2
Tighten the nuts to 31 Nm (23 lb-ft).
5. Install the EGT sensor into the RH turbocharger inlet pipe.
^
Tighten to 44 Nm (32 lb-ft).
6. Position the EGR-OC pipe and install a new EGR-OC pipe-to-horizontal EGR cooler gasket and loosely install the new bolts.
7. CAUTION: Make sure the correct bolts are installed in the bracket or damage to the exhaust gas recirculation (EGR)-oxidation catalytic
converter (OC) pipe may occur.
Install a new EGR-OC pipe-to-RH turbocharger inlet pipe gasket and loosely install new bolts. Loosely install new EGR-OC-to-turbocharger
bracket bolts.
8. Position the cylinder head bracket and install the EGR-OC bracket-to-cylinder head bracket washer and a new bolt. Loosely install the cylinder
head bracket-to-cylinder head washers and a new bolt. Finger tighten both bolts.
9. Tighten the EGR-OC-to-EGR cooler bolts.
^
Tighten to 31 Nm (23 lb-ft).
