F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Accumulator HVAC: Service and Repair
SUCTION ACCUMULATOR
Removal and Installation
1. Recover the refrigerant.
2. Disconnect the A/C cycling switch electrical connector.
3. Remove the RH fender splash shield.
4. Remove the suction accumulator outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
5. Remove the 2 suction accumulator nuts.
-
To install, tighten to 7 Nm (62 lb-in).
6. Disconnect the evaporator outlet fitting.
-
Discard the O-ring seals.
7. Remove the suction accumulator.
8. To install, reverse the removal procedure.
-
Install a new gasket seal and new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
