F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Steering Column Multifunction Switch (Part 2)
Removal and Installation
1. Remove the steering column opening trim.
2. Remove the tilt lever dust boot.
3. Remove the screw and the tilt lever.
^
To install, tighten to 6 Nm (53 inch lbs.).
4. Remove the 3 screws and the upper and lower steering column shrouds.
5. Disconnect the multi-function switch electrical connector.
6. Remove the 2 screws and the multi-function switch.
^
To install, tighten to 1 Nm (9 inch lbs.).
7. To install, reverse the removal procedure.
