F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
3. Disconnect and position aside the ABS module electrical connector.
4. Disconnect the steering gear shield from the line fitting and position the shield up on the lower steering column shaft.
F-250/350 vehicles
5. Disconnect the return hose-to-steering gear fitting.
^
Discard the O-ring seal.
^
To install, tighten to 35 Nm (26 ft. lbs.).
6. Unclip the return hose from the retainer clip.
All vehicles
7. Disconnect the pressure line-to-steering gear fitting.
^
To install, tighten to 35 Nm (26 ft. lbs.).
8. Disconnect the pressure line-to-jumper line fitting.
^
To install, tighten to 35 Nm (26 ft. lbs.).
9. Unclip the hydraulic booster-to-steering gear pressure line from the 2 pressure line retainers and remove the pressure line.
10. To install, reverse the removal procedure.
^
Install a new O-ring seal on the return hose-to-steering gear fitting.
^
Fill the power steering system.
