F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
6. Clean the following components:
-
The rear axle housing spindle.
-
All the old grease and axle lubricant from the rear hub.
-
The rear wheel bearings and cups.
7. Inspect the bearing races and rollers for pitting, galling or erratic wear patterns. Check the rollers for end wear. Discard the bearings, if necessary.
1. A typical new bearing roller.
2. A worn bearing roller.
Installation
1. For model 80, using the Rear Axle Drawbar and the Rear Wheel Hub Bearing Cup Installers 205-100 and 205-480, install the inner and outer
bearing cups. For model S110 or S130, use a suitable driver.
-
Check to see if a 0.038 mm (0.0015 in) feeler gauge can be inserted between the cups and the rear hub at any point around each cup. Reseat
the bearing cups, if necessary.
2. Install the inner rear wheel bearing in the rear hub.
3. Install a new rear hub seal.
-
For model 80, use a suitable seal installer.
-
For model S110 or S130, use the Wheel Hub Inner Wheel Installer and Adapter.
4. Position the rear brake disc on the rear hub and install the 8 bolts.
