F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
LABOR ALLOWANCES
PARTS REQUIREMENTS / ORDERING INFORMATION
Parts are not required to complete this repair.
Attachment III - Technical Information
OVERVIEW
In some of the affected vehicles, customers could experience one or a combination of the following symptoms: illuminated Malfunction Indicator Light
(M IL) or Wrench Light, runs rough, reduced power, excessive smoke from the exhaust, fuel smell from the crankcase, coolant loss, and/or unusual
engine noise. These symptoms could be caused by concerns that may eventually result in significant engine damage and a lengthy, costly service repair.
Dealers are to reprogram the Powertrain Control Module (PCM), and if applicable the Transmission Control Module (TCM) and Instrument Cluster
(IC).
SERVICE PROCEDURE
Module Reprogramming
NOTE:
Reprogram appropriate vehicle modules before performing diagnostics and clear all Diagnostic Trouble Codes (DTCs) after programming. For
DTCs generated after reprogramming, follow normal diagnostic service procedures.
1. Connect a battery charger to maintain battery charge during this reprogramming procedure.
2. Reprogram the PCM to the latest calibration using Integrated Diagnostic System (IDS) release 71.04 and higher. Calibration files may also be
obtained at the website. When reprogramming the PCM on automatic transmission equipped vehicles, the TCM will also be automatically
reprogrammed to the latest level.
3. Using the IDS, check the IC to verify it has the latest calibration installed. If the IC does not have the latest calibration installed, it will need to be
reprogrammed to bring it up to the latest calibration.
Important Information For Module Programming
NOTE:
When programming or reprogramming a module, use the following basic checks to ensure programming completes without errors.
^
Make sure the battery is fully charged before carrying out the programming steps and connect IDS/scan tool to a power source.
^
Inspect Vehicle Communication Module (VCM) and cables for any damage, make sure scan tool connections are not interrupted during
programming.
^
A hardwired internet connection is strongly recommended.
^
Turn off all unnecessary accessories (radio, heated/cooled seats, head lamps, interior lamps, HVAC system, etc.), close doors.
^
Disconnect/depower any aftermarket accessories (remote start, alarm, power inverter, CB radio, etc.).
^
Follow all scan tool on-screen instructions carefully.
^
Disable IDS/scan tool sleep mode, screensaver, hibernation modes.
^
Create all sessions Key On Engine Off (KOEO). Starting the vehicle before creating a session will cause errors within the programming inhale
process.
Recovering a PCM/Smart Junction Box (SJB) when programming has resulted in a blank module:
