F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
6. Bend wire 1 back in a straight line.
NOTE: Wait for solder to cool before moving wires.
7. Evenly position heat shrink tubing over wire repair.
NOTE: Overlap tubing on both wires.
8. Use shielded heat gun to heat the repaired area until adhesive flows Out of both ends of heat shrink tubing.
9. Reconnect battery ground cable.
Recommended splicing method - Crimp (For 10-22 AWG Diameter Wire to Like Wire Diameter)
1. Disconnect battery ground cable.
2. Strip 6.35mm (1/4 in) of insulation from each wire end, taking care not to nick or cut wire strands.
3. Install heat shrink tubing.
NOTE: Use heat shrinkable tubes marked with ES-1 (16-22 GA) or ES-2 (10-18 GA) to seal wire splice.
