F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
8. Insert the 3 rods through the middle plate of the special tool. The front 2 rods will pass through the hooks, the rear rod also passes through the
special tool lower plate. Thread the rods into the EGR valve bolt holes.
9. NOTE: The special tool has LH thread.
Install the special tool top plate and run the top plate down until it sits on the support rod nuts.
-
It may be necessary to adjust the support rods so that the plate sits squarely on top of the nuts.
10. NOTE: The special tool has LH thread.
Using the special tool, remove the EGR valve.
-
Discard the O-ring seal.
11. Using the special tool and a shop vacuum, clean the EGR valve bore in the intake throttle adapter.
-
Inspect the intake throttle adapter bore for scoring. If the bore is scored, install a new intake throttle adapter.
Installation
1. Using a new O-ring seal, install the EGR valve and the 3 bolts.
-
Tighten to 10 Nm (89 lb-in).
2. Connect the coolant inlet and outlet hoses.
3. Connect the EGRT sensor outlet and the EGR valve electrical connectors.
