F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
-
Tighten to 14 Nm (124 lb-in).
6. NOTE:
-
RH side shown, LH side similar.
-
Lightly lubricate the O-ring seal with clean engine oil.
Install the cylinder block coolant drain plug.
-
Tighten to 20 Nm (177 lb-in).
LH glow plug sleeve
7. CAUTION: To prevent engine damage, do not use air-powered tools when installing the valve cover.
NOTE: Alternately tighten the bolts to tighten evenly. Install new press-in-place gaskets.
Install the valve covers, bolts and stud bolts.
-
Tighten to 9 Nm (80 lb-in).
8. Position the LH valve cover lower bracket on the valve cover studs.
9. NOTE: The LH valve cover bracket assembly must be aligned to the turbocharger crossover tube before assembly nuts are tightened. Do not
tighten the nuts at this time.
Position the LH valve cover upper bracket on the lower bracket and valve cover studs, and loosely install the 3 nuts that mount the upper bracket
to the lower bracket.
10. Adjust the position of the LH valve cover bracket assembly so the turbocharger crossover tube is level and square to the turbocharger, and tighten
the 3 assembly nuts.
-
Tighten to 31 Nm (23 lb-ft).
11. Install the 3 nuts that attach the LH valve cover bracket assembly to the valve cover.
-
Tighten the LH valve cover bracket nuts to 9 Nm (80 lb-in).
12. Position the EP sensor tube assembly on the valve cover-to-LH valve cover bracket assembly stud and install the nut.
-
Tighten the EP sensor tube assembly nut to 9 Nm (80 lb-in).
13. Connect the EP sensor tube assembly fitting.
-
Tighten to 20 Nm (177 lb-in).
14. Install the 4 bolts for the turbocharger crossover tube.
-
Tighten to 31 Nm (23 lb-ft).
