F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
5. NOTE: During installation, 4 new air bag module deployment door screws must be installed.
Install the 4 new passenger air bag module deployment door screws.
6. Close the glove compartment door.
7. CAUTION: The clockspring electrical connector is unique and cannot be reversed when connected to the driver air bag module. Match
the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connector into the driver air bag
module. Failure to follow this instruction may result in component damage and/or system failure.
Connect the horn switch electrical connector, then connect the driver air bag module electrical connector.
8. Position the driver air bag module to the steering wheel, lining up the locator pins.
9. NOTE:
-
Make sure that all 3 driver air bag module wire clips are fully engaged and seated correctly to the steering wheel.
-
Audible clicks will be heard when the 3 driver air bag module wire clips are fully engaged.
Firmly press the driver air bag module to the steering wheel, seating the 3 driver air bag module wire clips to the steering wheel hooks.
-
Check the driver air bag module trim cover to the steering wheel for an even gap clearance and correct movement.
10. Install the steering column lower shroud.
11. Install the steering column upper shroud.
12. Install the 3 steering column lower shroud screws.
