F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
2. Remove the cap from the safety belt buckle nut.
3. Remove the nut, route the safety belt out of the strap and remove the safety belt buckle.
-
To install, tighten to 55 Nm (41 lb-ft).
RH safety belt buckle
4. Remove the cap from the safety belt buckle nut.
5. Remove the nut, route the safety belt out of the strap and remove the safety belt buckle.
-
To install, tighten to 55 Nm (41 lb-ft).
All safety belt buckles
6. NOTE:
-
Make sure the safety belt webbing is not twisted prior to installation.
-
After installation, make sure the safety belt is positioned in the retaining strap.
To install, reverse the removal procedure.
7. Check the active restraint system for correct operation.
