F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion, a new
safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its
original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and
attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the
risk of serious personal injury or death in a crash.
1. Remove the rear seat backrest.
2. Remove the B-pillar trim panel.
3. Remove the safety belt retractor.
-
Remove the bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
-
Disengage the safety belt retractor anti-rotation tab from the sheet metal and remove the safety belt retractor.
4. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
5. Check the active restraint system for correct operation.
