F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
4. Disconnect the pressure line-to-pump fitting.
^
To install, tighten to 35 Nm (26 ft. lbs.).
5. Disconnect the steering gear shield from the line fitting and position the shield up on the lower steering column shaft.
6. Disconnect the return hose-to-steering gear fitting.
^
Discard the O-ring seal.
^
To install, tighten to 35 Nm (26 ft. lbs.).
7. Disconnect the pressure line-to-steering gear fitting and remove the pressure line.
^
To install, tighten to 35 Nm (26 ft. lbs.).
8. To install, reverse the removal procedure.
^
Install a new O-ring seal on the return hose-to-steering gear fitting.
^
Fill the power steering system.
