F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power
steering components may result.
NOTE: New Teflon(R) seals must be installed any time the power steering line fittings are disconnected.
1. Remove the power steering pump pulley.
2. Remove the pressure line/supply hose bracket nut.
^
To install, tighten to 18 Nm (13 ft. lbs.).
3. Release the clamp and disconnect the power steering pump supply hose.
4. Disconnect the pressure line-to-pump fitting.
^
Remove and discard the Teflon(R) seal.
^
To install, tighten to 35 Nm (26 ft. lbs.).
5. Remove the 3 bolts and the power steering pump.
^
To install, tighten to 25 Nm (18 ft. lbs.).
6. NOTE: Make sure that the power steering pump bolts are installed in their original positions.
NOTE: Thoroughly clean all foreign material from the pressure line-to-pump threads before installing the fitting.
To install, reverse the removal procedure.
^
Using the special tool, install a new Teflon(R) seal on the pressure line fitting.
^
Fill the power steering system.