F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Tie Rod End: Service and Repair
Tie Rod End - Outer, LH
Tie Rod End - Outer, LH, F-250 and F-350 Four Wheel Drive (4WD), F-450, F-550
Special Tool(s)
Removal and Installation
1. Place the steering wheel in the straight-ahead position.
2. Remove the wheel and tire.
3. Loosen the LH outer tie-rod adjusting sleeve clamp nut.
^
To install, tighten to 55 Nm (41 ft. lbs.).
4. Remove the LH outer tie-rod end cotter pin, nut retainer and nut.
^
Discard the cotter pin.
-
To install, tighten to 115 Nm (85 ft. lbs.).
5. NOTE: Count the number of turns required to remove the LH outer tie-rod end for reference during assembly.
Using the special tool, disconnect the LH outer tie-rod end from the wheel knuckle and remove the LH outer tie-rod end.
6. CAUTION: Make sure that the tie-rod end nut retainer is correctly positioned on the tie-rod end nut to allow for cotter pin installation.
Do not tighten or loosen the nut to align the retainer slot with the cotter pin hole. Overtightening of the fasteners may result in premature
failure of steering linkage components.
To install, reverse the removal procedure.
^
Check and, if necessary, adjust the toe.
