F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
5. Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, remove the upper ball joint.
Installation
NOTICE: The grease fitting must be removed from the ball joint prior to installation or damage to the grease fitting can occur.
NOTICE: To avoid damage to components, do not use heat to aid installation.
NOTE: Clean the wheel knuckle ball joint bore.
1. Position the ball joint into the wheel knuckle.
NOTE: The upper ball joint must be installed first.
2. Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, install the upper ball joint.
3. Using the C-Frame and Screw Installer/Remover and the Ball Joint Remover/Installer, install the lower ball joint.
4. Install the snap ring in the groove at the bottom of the lower ball joint.
NOTICE: Do not overtighten the ball joint grease fitting or damage to the ball joint may occur.
5. If removed, Install the ball joint grease fitting.
6. Install the wheel knuckle.
