F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
10. CAUTION: The knuckle bore must be clean enough to allow the special tool to seat completely by hand. Do not press or draw the wheel
knuckle seal and axle shaft into place or damage to the seal may occur.
NOTE: Do not apply any lubricant to the surface of the wheel knuckle bore.
Position the axle shaft and main seal in to the wheel knuckle and axle housing.
11. NOTE: F-450/F-550 shown, F-250/F-350 similar.
Position the special tool onto the axle shaft and install the snap ring.
12. NOTE: F-450/F-550 shown, F-250/F-350 similar.
Using the special tools, install the wheel knuckle seal and axle shaft.
13. Install the wheel bearing and wheel hub.
14. If equipped, connect the PVH hose.
