F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
21. Remove the middle transmission fluid cooler tube.
22. CAUTION: A backup wrench must be used on the remote mounted transmission fluid filter housing while disconnecting and connecting
the transmission fluid cooler tubes or damage to the filter housing will occur.
Using a backup wrench, disconnect the rear transmission fluid cooler tubes from the remote mounted transmission fluid filter.
23. Remove the remote mounted transmission fluid filter-to-bracket bolt and remove the filter.
24. Remove remote mounted transmission fluid filter bracket bolts and the bracket.
All vehicles
25. Disconnect the rear transmission fluid cooler tubes from the transmission case and remove them from the vehicle.
Installation
All vehicles
1. Install the rear transmission fluid cooler tubes into the vehicle and connect the transmission fluid cooler tubes to the transmission case.
^
Tighten to 40 Nm (30 ft. lbs.).
Early build vehicles
2. Install the remote mount transmission fluid filter bracket and bolts.
^
Tighten to 35 Nm (26 ft. lbs.).
3. Install the remote mounted transmission fluid filter and install the filter-to-bracket bolt.
^
Tighten to 11 Nm (8 ft. lbs.).
4. CAUTION: A backup wrench must be used on the remote mounted transmission fluid filter housing while disconnecting and connecting
the transmission fluid cooler tubes or damage to the filter housing will occur.
Using a backup wrench, connect the rear transmission fluid cooler tubes to the remote mounted transmission fluid filter.
^
Tighten to 40 Nm (30 ft. lbs.).
5. Install the middle transmission fluid cooler tubes.
6. Connect the middle transmission fluid cooler tubes to the remote mount fluid filter housing.
7. Install the remote mount transmission fluid filter secondary latches.
8. Connect the front, RH ABS electrical connector.
All vehicles
9. Lower the engine.
