F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
cylinder and the switch wiring connector must be in the 12 o'clock position. Incorrect installation will damage the clutch pedal position switch and
cause insufficient clutch pedal travel.
To install, reverse the removal procedure noting the following:
^
Correctly position the CPP switch when installing it on the clutch master cylinder push rod.
^
Seat the clutch master cylinder rubber seal to the bulkhead after locking the clutch master cylinder in the clutch pedal and support bracket.
^
Make sure to slide the heat shield forward and over the slave cylinder until it contacts the transmission case.
