F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. To maintain driveline balance, index-mark the driveshaft flange and the pinion flange.
3. Remove and discard the 4 driveshaft flange bolts.
4. NOTICE: The driveshaft flange fits tightly on the rear axle flange pilot. Using a suitable tool, pry only in the area shown to disconnect
the driveshaft flange or damage to the driveshaft may occur.
NOTE: It may be necessary to tap the driveshaft flange with a plastic or rubber soft-faced hammer if a pry area is not available on the driveshaft
flange.
NOTE: Do not allow the driveshaft to hang unsupported.
Using a suitable tool as shown, disconnect the driveshaft flange from the pinion flange and support the driveshaft using mechanic's wire.