F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
5. NOTE: Index-mark the flange to the pinion shaft.
Using the Drive Pinion Flange Holding Fixture to prevent the flange from turning, remove and discard the pinion shaft locknut and washer.
6. Using the 2 Jaw Puller, remove the pinion flange.
7. Using the Slide Hammer and Bushing Remover, remove the pinion seal.
8. Clean the rear axle pinion seal seat.
Installation
1. NOTICE: If the pinion seal becomes cocked during installation, remove the seal and install a new one. Make sure the garter spring
remains in place during assembly. If the spring is dislodged, a new pinion seal must be installed or damage to the component may occur.
Using the Drive Pinion Oil Seal Installer, install the pinion seal.
-
Coat the pinion seal (rubber lips) with lubricant.
2. NOTICE: The pinion flange must never be hammered on or installed with power tools or damage to the component may occur.
NOTE: Align the pinion-to-flange index marks.
Using the Drive Pinion Flange Installer, install the pinion flange.
