F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Slip Yoke: Service and Repair
Driveshaft Slip Yoke
Disassembly
1. Remove the driveshaft from the vehicle. For additional information, refer to Driveshaft - Front See: Drive/Propeller Shaft/Service and
Repair/Removal and Replacement/Driveshaft - Front or Driveshaft - Rear, One-Piece, Four Wheel Drive (4WD) .
2. NOTE: Do not clamp the driveshaft in the jaws of a vise or a similar holding fixture.
Place the driveshaft on a suitable workbench.
3. Index-mark the driveshaft slip yoke and the stub shaft.
4. Remove the driveshaft slip yoke.
1. Cut and discard the 2 driveshaft slip yoke boot clamps.
2. Separate the driveshaft slip yoke from the stub shaft.
5. Remove and discard the driveshaft slip yoke boot.
6. Check the lubricant for contamination. If the lubricant feels gritty, clean and inspect the stub shaft and driveshaft slip yoke for wear. Install new
