F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
4. Press on the spider to remove the remaining bearing cup.
5. Remove the slip-yoke.
Final disassembly
6. Repeat Bearing cup removal in this procedure to remove the remaining bearing cups and the spider from the shaft.
7. Clean the yoke area at the end of the shaft.
Assembly
Bearing cup installation
1. NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other kits.
Install a new spider and bearing cup.
1. Start a new bearing cup in the shaft yoke.
-
Check the needle bearings for correct positioning.
2. Position the new spider in the shaft yoke.
3. Press the bearing cup to just below the snap ring groove.
2. NOTE: Use the yellow snap rings supplied in the kit to assemble the U-joint. If difficulty is encountered with the yellow snap rings, install the
black snap rings.
Remove the shaft from the C-Frame and Screw Installer/Remover, and install the new snap ring.
Opposite bearing cup installation
3. Repeat Bearing cup installation in this procedure to install the new bearing cup and snap ring on the opposite side of the shaft yoke.
