F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
3. Rotate the flange 180 degrees.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the flange.
Final disassembly
6. Repeat Bearing cup removal in this procedure to remove the remaining bearing cups and the spider from the driveshaft.
7. Clean the yoke area at the end of the driveshaft.
Assembly
Bearing cup installation
1. NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other kits.
Install a new spider and bearing cups.
1. Start a new bearing cup in the driveshaft yoke.
-
Check the needle bearings for correct positioning.
2. Position the new spider in the driveshaft yoke.
3. Position the driveshaft yoke in the C-Frame and Screw Installer/Remover.
4. Press the bearing cup to just below the snap ring groove.
-
Repeat to install the new bearing cup on the opposite side of the driveshaft yoke.
Flange installation
2. Inspect the flange. Install a new flange, if necessary.
3. Install the new bearing cups and the flange.
1. Start a new bearing cup in the flange.
-
Check the needle bearings for correct positioning.
2. Position the flange on the spider.
3. Position the assembly in the C-Frame and Screw Installer/Remover.
4. Press the bearing cup to just below the snap ring groove.
-
Repeat to install the new bearing cup on the opposite side of the flange.
