F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
3. Position the opposite bearing cup on the spider trunion.
4. Using the C-Frame and Screw Installer/Remover, press the bearing cup to just below the snap ring groove.
5. Install the new snap ring.
6. Using the C-Frame and Screw Installer/Remover, press the opposite bearing cup to just below the snap ring groove.
7. Install the new snap ring.
8. NOTE: Align the index marks made during disassembly.
Position the driveshaft center yoke on the spider.
9. Using the C-Frame and Screw Installer/Remover, press the bearing cups into position.
-
Install the snap rings.
10. Install the original spring.