F 350 4WD Super Duty V8-6.4L DSL Turbo (2008)
Position the transfer case control to the transmission. Align the new transfer case control pivot bolt over the correct mounting hole in the
transmission case and start the bolt into the threaded hole by hand.
1. For vehicles with a gasoline engine and manual transmission, or a diesel engine and manual or automatic transmission, install the new bolt in
the forward (LH) threaded hole in the transmission case.
2. For vehicles with a gasoline engine and automatic transmission, install the new bolt in the rearward (RH) threaded hole in the transmission
case.
2. Position the transfer case control bracket bolt in the unused threaded hole in the transmission case.
^
For vehicles with a gasoline engine and manual transmission, or a diesel engine and manual or automatic transmission, position the pin in the
rearward (RH) threaded hole in the transmission case.
^
For vehicles with a gasoline engine and automatic transmission, position the pin in the forward (LH) threaded hole in the transmission case.
3. NOTE: Verify that the transfer case is still in 4H.
Connect the shift linkage to the lower shifter arm.
4. CAUTION: Make sure the transfer case is in 4H. Hold the control lever against the 4H detent while tightening the bolt. This will make
sure of correct transfer case gear engagement during transfer case operation.
Hold the control lever against the 4H detent while tightening the transfer case control lever pivot bolt.
^
Tighten to 40 Nm (30 ft. lbs.).
