F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
If a greaseable lower ball joint is installed, it must be serviced per the below schedule:
^
At every oil change or at 8000 kilometer (5000 mile) intervals (whichever comes first)
The recommended lubricants are:
^
Premium Long Life Grease (XG-1-C, or equivalent meeting Ford Specification ESA-M1C75-B)
^
Hi-Temp Wheel Bearing Grease (E8TZ-19590-A, or equivalent meeting Ford Specification ESA-M1C198-A)
4.
Measure steering gear meshload. Reference the appropriate Workshop Manual for the procedure for measuring meshload.
a.
If it is less than 0.45 Nm (4 lb-in), reset to 0.56-0.68 Nm (5-6 lb-in).
NOTE:
THE MESHLOAD MEASUREMENT IS THE AMOUNT OF THE TORQUE INCREASE THAT THE TORQUE WRENCH SHOWS AS THE
STEERING WHEEL IS ROTATED THROUGH THE CENTER OF ITS TRAVEL (I.E., IF THE STEERING WHEEL TORQUE TO ROTATE IS
MEASURED AT 0.45 Nm (4 LB-IN) ON THE ENDS, AND THEN IT MEASURES 1.13 Nm (10 LB-IN) AS IT IS ROTATED THROUGH THE
CENTER, MESHLOAD 0.68 Nm (6 LB-IN). MESHLOAD = CENTER - END (1.13 Nm - 0.45 Nm = 0.68 Nm OR 10 LB-IN - 4 LB-IN = 6 LB-IN
OF MESHLOAD).
b.
Once meshload is OK, procedure is complete. Return vehicle to customer.
Parts Information
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION/DESCRIPTION/TIME
DEALER CODING
OASIS CODES: 303000
Technical Service Bulletin # 03-19-10
Date: 030929
Brakes - Vehicle Pulls Left/Right on Braking
Article No.
03-19-10
09/29/03