F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
2. Place the special tool on the differential case hubs, and position the assembly into the differential housing.
^
For model 50 axles, use special tool 205-DO46.
^
For model 60 axles, use special tool 205-13047.
3. NOTE: Use a Dial Indicator with a minimum travel capacity of 5.08 mm (0.200 inch).
NOTE: Repeat this step until there is a consistent reading.
Determine the total thickness of differential bearing shims to install on the differential case hubs, less the preload, which is calculated later in this
procedure. Record this measurement as the total case end play.
1
Position the special tool.
2
Position the special tool.
^
Locate the tip of the tool on a flat surface of one of the ring gear bolt spot faces.
3
Force the ring gear as far as possible toward the special tool.
4
With the pressure still applied, zero the special tool.
5
Force the ring gear as far as it will go in the opposite direction.
6
Record the reading.
