F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
2. Thread two studs into the axle housing 180 degrees apart. This will eliminate rotation of the carrier assembly after it makes contact with the gasket
material.
3. WARNING: Secure the carrier to the jack to prevent it from falling. Failure to follow these instructions may result in personal injury.
Position the carrier into the axle housing.
4. CAUTION: Make sure the bolt threads are clean.
Apply Thread lock 262 E2FZ-19554-B or equivalent meeting Ford specification WSK-M2G351-A6 to the bolt threads, and install the bolts.
^
Remove the two alignment studs only after installing several of the bolts.
^
tighten the bolts in a cross pattern.
5. Install the axle shafts.