F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F (2001)
Shifter Transfer Case: Service and Repair
New Assembly
Transfer Case Shift Lever-New Assembly
Removal
CAUTION: A breakaway pin, found only on a new transfer case control lever assembly detent plate, holds the lower shifter arm in the 2H detent
position during installation. This ensures correct transfer case gear engagement during transfer case operation. Carry out this procedure only if
installing a new transfer case control lever assembly. If reinstalling the original transfer case control lever assembly, refer to Transfer Case Shift
Lever-Original Assembly.
1. Shift the transfer case into 2H.
2. Remove the screws that attach the bezel and boot assembly to the floor.
3. Remove the bolt that attaches the shift lever to the transfer case control lever assembly, and remove the shift lever, and the bezel and boot
assembly.
1
Slide the bezel and boot assembly upward on the shift lever.
2
Remove the bolt, the shift lever, and the bezel and boot assembly.
4. Raise and support the vehicle.
5. Disconnect the control rod from the lower shifter arm.