F 450 2WD Super Duty V10-6.8L VIN S (1999)
Engine Control Module: Removal and Replacement
REMOVAL
1. Disconnect the battery ground cable.
CAUTION: Always disconnect the battery ground cable prior to working on the electronic engine controls.
2. Remove the bolt, screws and pushpins. Position the fender apron out of the way.
3. Remove the bolt and disconnect the Powertrain Control Module (PCM) electrical connector.
4. Remove the screws and remove the PCM and the bracket assembly.
5. Separate the Powertrain Control Module (PCM) from the bracket.
INSTALLATION