F 450 2WD Super Duty V10-6.8L VIN S (1999)
Air Bag Control Module: Service and Repair
ModuleAir Bag Electronic Crash Sensor (ECS)
Removal
WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and
wait one minute. Be sure to disconnect auxiliary batteries and power supplies (if so equipped).
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE: Repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform
the diagnostic procedure again.
1. Disconnect the battery ground cable (14301).
2. Remove the air bag Electronic Crash Sensor (ECS) module cover.
3. Disconnect the air bag electronic crash sensor (ECS) module.
1
Disconnect the ECS electrical connector locking clip.
2
Disconnect the ECS electrical connector.
3
Remove the ECS retaining screw.
4. Remove the ECS module.
1
Remove the ECS retaining screws.
2
Remove the ECS module.
