F 450 2WD Super Duty V10-6.8L VIN S (1999)
6. CAUTION: Be careful not to damage the manual control lever bore.
NOTE: The manual control lever and manual control lever shaft are one piece.
NOTE: Use a crescent wrench on the manual control lever or outer flats of manual control lever shaft assembly when removing the inner manual
valve detent lever nut.
Remove the manual control lever shaft assembly.
1
Remove the nut.
2
Remove the manual control lever shaft assembly.
7. Remove the manual control lever seal.
1
Install the Puller.
2
Remove the seal.
Installation
1. NOTE: Prior to installing the manual control lever seal, clean the bore opening with mineral spirits.
Using the Shift Lever Seal Replacer to install the manual control lever seal.
