F 450 2WD Super Duty V10-6.8L VIN S (1999)
Drive/Propeller Shaft: Service and Repair
One-Piece, With 137-Inch and 141-Inch Wheel Base
Removal
1. Raise and support the vehicle.
2. Index mark the driveshaft at the axle flange.
3. WARNING: Replace with new bolts and retainers after the third removal.
Disconnect the driveshaft from the axle flange.
1
Mark and remove the driveshaft to rear axle bolts.
2
Remove the U-joint retainers.
4. NOTE: Index mark the output shaft to the slip, yoke.
For vehicles equipped with an automatic transmission, lower the driveshaft and slide the driveshaft rearward off the transmission output shaft.
^
Plug the extension housing to prevent fluid. loss.
5. WARNING: Replace with new bolts after the third removal.
NOTE: Index mark the driveshaft to the transmission flange.
For vehicles equipped with a manual transmission, mark and remove the driveshaft to transmission flange bolts.
6. Remove the driveshaft.
Installation
