F 450 2WD Super Duty V10-6.8L VIN S (1999)
4. Position the rear driveshaft assembly and install the center support bearing bolts.
^
Hand tighten only; do not tighten at this time.
5. WARNING: Replace with new bolts and retainers after the third removal.
NOTE: Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent.
Connect the rear driveshaft assembly to the front driveshaft.
6. WARNING: Replace with new bolts and retainers after the third removal.
NOTE: Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent.
Connect the rear driveshaft assembly to the rear axle.
7. Tighten the driveshaft center support bearing bolts.