F 450 2WD Super Duty V10-6.8L VIN S (1999)
7. Cut the adhesive applicator tip to specification, then apply an 11 mm (0.43 inch) wide bead of Urethane High Viscosity Adhesive
WSB-M2G316-B to the entire primed area of the pinch weld.
NOTE: The windshield glass must be positioned within 10 minutes of applying the urethane sealant.
8. Position the windshield glass on the vehicle pinch weld, aligning it with the marks.
CAUTION: After placing the urethane installed glass, the vehicle must not be driven until the urethane has cured. The curing time at
temperatures above 13°C (55°F) and relative humidity above 50% is 12-24 hours (decreasing at higher temperatures and lower humidities).
Inadequate curing of the urethane can adversely affect the strength of the urethane sealant bond.
NOTE: Before installing the windshield glass, open the windows to prevent the windshield glass from being pushed out by air pressure as the
door is closed.
9. Install the roof trim panel.
10. Install the A-pillar mouldings.
11. Install the inside rear view mirror.
12. Install the cowl vent panels.
13. Install the windshield wiper arms.
14. Install the antenna.
