F 450 2WD Super Duty V10-6.8L VIN V (2005)
Antenna Cable: Service and Repair
ANTENNA LEAD-IN CABLE
Removal
1. Remove the antenna base.
2. Position the RH front fender splash shield away from the bulkhead.
1
Remove the 2 nuts.
2
Remove the screws.
3
Remove the pin-type retainers.
4
Position the RH front fender splash shield away from the bulkhead.
3. Remove the pin-type retainer and the lower RH A-pillar trim panel.
4. Unseat the old radio antenna lead-in cable grommet from the bulkhead and pull the excess cable into the passenger compartment.
5. Remove the audio unit.
6. NOTE: This vehicle uses a radio antenna lead-in cable that is attached to the instrument panel reinforcement and the defroster air duct. Do not
remove the old radio antenna lead-in cable from the vehicle.
Cut and remove the original radio antenna lead-in cable connectors and excess cable. Secure the remaining cable ends to avoid rattles or
identification problems.
Installation