F 450 2WD Super Duty V10-6.8L VIN V (2005)
7. NOTE:
-
Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
-
No lubricants of any kind are to be used during body insulator installation.
To install, reverse the removal procedure.
Body Support - Front Upper
BODY SUPPORT-FRONT UPPER
Removal and Installation
1. CAUTION: When removing upper body insulators, all other body mount support bolts must be loose before raising the vehicle cab to
prevent permanent structural damage from occurring to the vehicle cab.
Remove the lower body insulator.
2. Remove the opposite side front body insulator bolt.
3. NOTE: Step 3 is for Crew Cab vehicles only.
Remove and discard the left and right middle insulator bolts.
4. NOTE: Choose the proper procedure to match the vehicle that is being serviced.
Remove and discard the left and right rear body insulator bolts.
5. Raise the vehicle body enough to allow removal of the insulator.
6. Remove the insulator.