F 450 2WD Super Duty V10-6.8L VIN V (2005)
Brake Caliper: Service and Repair
Brake Caliper Anchor Plate, Front
Brake Caliper Anchor Plate
Material
Removal and Installation
1. Remove the brake pads.
2. Remove and discard the 2 brake caliper anchor plate bolts.
^
On F-250, F-350, tighten to 225 Nm (166 ft. lbs.).
^
On F-450, F-550, tighten to 400 Nm (295 ft. lbs.).
3. Inspect the brake caliper anchor plate assembly.
^
Check the guide pin boots for damage.
^
Check the guide pins for binding and damage.
^
Replace worn or damaged pins. Lube the pins with silicone grease.
4. To install, reverse the removal procedure.
