F 450 2WD Super Duty V10-6.8L VIN V (2005)
7. Position the A/C compressor and install the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
8. Position the power steering pump and install the 3 bolts.
^
Tighten to 25 Nm (18 inch lbs.).
9. Position the starter electrical harness support bracket and install the bolt.
^
Tighten to 10 Nm (89 inch lbs.).
10. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Using a new O-ring seal, install the camshaft position (CMP) sensor and the bolt.
^
Tighten to 10 Nm (89 inch lbs.).
11. Connect the CMP sensor electrical connector.
12. Install the LH radio ignition interference capacitor and the nut.
^
Tighten to 10 Nm (89 inch lbs.).
13. Install the RH radio ignition interference capacitor and the nut.
^
Tighten to 10 Nm (89 inch lbs.).
