F 450 2WD Super Duty V10-6.8L VIN V (2005)
14. NOTE: LH shown, RH similar.
Connect the radio ignition interference capacitor electrical connectors.
15. Install the accessory drive belt tensioner and the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
16. Install the coolant pump pulley and the 4 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
17. Install the accessory drive idler pulley and the 3 bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
18. Lubricate the engine front cover and the crankshaft seal inner lip with clean engine oil.
19. Using the special tools, install the crankshaft seal into the engine front cover.
20. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use silicone gasket
remover and metal surface prep. Follow the directions on the packaging. Failure to follow this procedure can cause future oil leakage.
