F 450 2WD Super Duty V10-6.8L VIN V (2005)
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
21. Use the special tool to install the crankshaft pulley.
22. Tighten the new crankshaft pulley bolt in 4 stages.
^
Stage 1: Tighten to 90 Nm (66 ft. lbs.).
^
Stage 2: Loosen 360 degrees.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs.).
^
Stage 4: Tighten an additional 90 degrees.
23. Rotate the tensioner clockwise and install the accessory drive belt.
24. Install the RH valve cover.
25. Install the LH valve cover.
26. Install the engine cooling fan.
27. Fill the crankcase with clean engine oil.