F 450 2WD Super Duty V10-6.8L VIN V (2005)
Alignment: Service and Repair
Lean Correction - Front
Lean Correction - Front
1. If lean correction is required, remove the high side front coil spring.
2. Compare the height of the original front coil spring with a new one with the same part umber. Note the difference.
3. If the original front coil spring exceeds the height of the new one by 13 mm (1/2 inch), install the new front coil spring in the vehicle.
4. If the original front coil spring is shorter than the new one by at least 13 mm (1/2 inch), remove the low side front coil spring from the vehicle.
5. Compare all three front coil springs and select the two most evenly matched for installation.
6. From the two most evenly matched coil springs, select the tallest and install it on the lower side of the vehicle. Install the shorter of the two on the
higher side of the vehicle.
