F 450 2WD Super Duty V10-6.8L VIN V (2005)
Air Bag Control Module: Service and Repair
RESTRAINTS CONTROL MODULE (RCM)
Removal
WARNING:
-
The restraints control module (RCM) orientation is critical for proper air bag supplemental restraint system (SRS) operation. If a vehicle
equipped with an SRS system has been involved in a collision in which the center tunnel area has been damaged, inspect the mounting
and bracket for deformation. If damaged, the RCM must be replaced whether or not the air bags have deployed. In addition, make sure
the area of the RCM mounting is restored to its original condition.
-
Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the
sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform the
diagnostic procedure again.
1. Depower the system.
2. NOTE: The RCM is mounted on the center tunnel under the instrument panel.
Pull out to release the retaining clips and remove the restraint control module (RCM) cover.
3. Disconnect the restraint control module RCM.
1
Disconnect the RCM electrical connector locking clip.
2
Disconnect the RCM electrical connector.
3
Remove the RCM retaining screw.
