F 450 2WD Super Duty V10-6.8L VIN V (2005)
4. Using the special tool, remove the pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, discard the pulley. If there is no paint or 1 paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
Installation
All vehicles
1. CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed 2 times.
Using the special tool, install the power steering pump pulley.
2. NOTE: Vehicle with air conditioning shown; vehicles without air conditioning similar.
Rotate the tensioner and install the accessory drive belt on the power steering pump pulley.
^
For vehicles with air conditioning, rotate the tensioner clockwise.
^
For vehicles without air conditioning, rotate the tensioner counterclockwise.
Vehicles with 6.0L engine
3. Install the engine cooling fan.
